Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Por um escritor misterioso
Descrição
I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan
TPU Vol. Flow rate issue. Any solution rather than entering speeds by calculating ? : r/BambuLab
I must be doing something wrong. Help please comments. : r/BambuLab
How to do support structures for small round overhangs in Bambu Studio : r/BambuLab
Help with overhangs : r/BambuLab
Bambu Studio: How & WHY to use Support Overhang Shading. Also Orca! Bambu Lab P1P - P1S - X1C
How to do support structures for small round overhangs in Bambu Studio : r/BambuLab
Interesting post - wonder when it'll come to Bambu Studio! These impossible overhangs were printed with zero support material thanks to a new 3D printing technique called arc overhangs. Available now for
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
Why are my consistent overhang issues getting worse? - General discussions - Bambu Lab Community Forum
Overhang Issues - General discussions - Bambu Lab Community Forum
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
AMS results for Bambu Lab X1-Carbon - FDM 3D Printers - 3DPrintBeginner Forum
How do I get everything to print at the same speed? - Troubleshooting - Bambu Lab Community Forum
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
Are arc overhangs coming to Bambu studio? - Bambu Lab Software - Bambu Lab Community Forum
de
por adulto (o preço varia de acordo com o tamanho do grupo)
